Thermotouch 9.2mG Glass Manual Programmable Thermostat
This modern manual thermostat makes controlling your underfloor heating a breeze. Simple on/off controls, temperature adjustments that are easy to regulate, and temperature limitations that can be adjusted ensure that your home is at the optimum temperature. This product also includes floor and ambient temperature sensors, allowing you to control the temperature of your underfloor heating systems.
Technical Data
| Size | 85x85x46mm (31mm in wall) |
| Protection Rating | IP30 |
| Max Load | 16A |
| Colour | 5215: Ice White 5216: Piano Black |
| Temperature Range | 5 ~ 80°C (0.5°C increments) |
| Sensor rating | NTC 10kΩ @ 25°C |
| Warranty | 3yrs |
Downloads
Manual control
Thermotouch 9.2mG has a simple manual mode that allows you to control the temperature of your underfloor heating manually.
Sensor mode
To offer total control over your heating system, Thermotouch 9.2mG comes with a floor sensor probe and the option of employing an ambient sensor.
Back box supplied
For convenience of installation, a back box is included for use with plaster walls.
Use with home automation
Thermotouch 9.2mG includes a “On as Before” mode that allows you to customize your comfort level and use it with off-peak electricity or Home Automation systems.
Frequently Asked Questions
Although each circumstance is unique, it is recommended that you start by setting your underfloor heating to 24°C. Increase or lower the temperature after several days of testing to discover your comfort temperature. Please keep in mind that a 1°C drop in temperature may not have a significant impact on the comfort or warmth of the floor, but it can help to save operating expenses.
A floor sensor is a small probe that is placed beneath the floor, in the space between two lengths of heating cable. This is connected to the thermostat and provides a precise temperature readout of the floor.
Yes! Thermogroup's Underfloor Heating Thermostats include a Floor Sensor as well as a 20mm flexible conduit to install the sensor in, making it easier to repair if necessary. The Floor Sensor and Conduit are located beneath the unit in your Thermostat box.
No, you'll need an unique controller for each zone you want to have individual control over.
Yes, this Thermotouch 9.2mG Glass Manual Thermostat may be connected to and controlled by your C-Bus system if purchased with your underfloor heating.
The electrician will need to connect mains electricity to the thermostat site before roughing in for our underfloor heating and controller. The electrician will next run two 20mm conduits from the thermostat position to the floor, one for the Underfloor Heating Cold Tail and the other for the Floor Sensor. Please see our Conduit Requirements pdf for more information and a graphic representation.